FIRMWARE:OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33) MODEM:ARRIS SURFBoard SB8200 ROUTER:Linksys WRT32X USB NAS:Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
Joined: 05 Apr 2017 Posts: 981 Location: Louisiana, USA
Posted: Thu Jul 05, 2018 2:11 Post subject:
Good. Next step is to get rid of the WRT3200ACM firmware on the opposite partition. Until you do, you don't have the safety of a second partition to fall back on if something goes wrong.
In Administration Tab - Firmware Upgrade Sub Tab upgrade firmware with the file you just downloaded. _________________ DD-WRT Installation & Setup TUTORIAL http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
FIRMWARE:OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33) MODEM:ARRIS SURFBoard SB8200 ROUTER:Linksys WRT32X USB NAS:Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
Joined: 05 Apr 2017 Posts: 981 Location: Louisiana, USA
Posted: Thu Jul 05, 2018 2:25 Post subject:
Scafidi454 wrote:
I have done that already. How does that change the other partition?
Every time you upgrade the firmware it flashes & reboots to the opposite partition. It's a safety feature of the WRT routers so you can easily recover from a bad flash. _________________ DD-WRT Installation & Setup TUTORIAL http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
FIRMWARE:OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33) MODEM:ARRIS SURFBoard SB8200 ROUTER:Linksys WRT32X USB NAS:Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
FIRMWARE:OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33) MODEM:ARRIS SURFBoard SB8200 ROUTER:Linksys WRT32X USB NAS:Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
Well, lost it again; tried to upgrade to OpenWRT file you linked to earlier, but it won't reset after the 30-30-30 or 3x power switch...But then tried the 3x power switch again and it worked! Hmm.. Guess I'm stuck with this dd-wrt...
So, OpenVPN status doesn't show anything now (where it was showing something before; nothing has changed to the config).
I noticed this when my wireless stopped working, which I was only able to get back just recently (printing purposes), but still cannot print when both show valid IPs (computer and printer) with same gateway (10.0.1.1).
Any ideas?
UPDATE: Got Wireless Internet back on Printer and Computer, but still cannot print (even after running EpsonNetSetup again).
I just want to put this thing into access point mode as the OpenVPN status still shows nothing while the VPN settings are set correctly and were working earlier this week.
I still cannot print wirelessly with valid IPs on router and printer. So, I'm wondering if the DNSMasq options I set for the VPN are affecting it as I do not have AP isolation enabled.
Also, I can see the MAC address of the printer in the LAN and Wireless status pages.
