Posted: Fri Jun 29, 2018 18:44 Post subject: Newer Build Kills Bandwidth?
I recently upgraded DD-WRT on my DLink DIR-890L router, from a July, 2017 release, to the more recent r35531. Had some issues getting there (see topic 315606), but it seems to be running fine.
Except bandwidth... On the 2017 release, I was consistently getting approximately 900Mbs down. Following the upgrade to r35531, it's barely making 200Mbs. Ping times are also a bit higher. This is from a wired machine.
SFE is enabled; QoS is disabled. I'm not sure what else to look at, but I'd like to reclaim all my bandwidth.
Kernel is at v4.4, so it would seem that I should be good to go based on the details with this releases announcement.
Is there possibly an issue with this release, or should I try another one? As mentioned, I had quite a time getting to r35531, so I'm a bit hesitant to start again, but will gladly do so if there's a better release I should be running.
Posted: Sat Jun 30, 2018 2:55 Post subject: Re: Newer Build Kills Bandwidth?
DBB wrote:
Had some issues getting there (see topic 315606), but it seems to be running fine.
Except bandwidth... On the 2017 release, I was consistently getting approximately 900Mbs down. Following the upgrade to r35531, it's barely making 200Mbs. Ping times are also a bit higher. This is from a wired machine.
SFE is enabled; QoS is disabled.
Did you erase nvram per Malachi in that thread? (`erase nvram` is the command from telnet). If that doesn't help after manual setup, try 36168. _________________ #NAT/SFE/CTF: limited speed w/ DD#Repeater issues#DD-WRT info: FAQ, Builds, Types, Modes, Changes, Demo#
OPNsense x64 5050e ITX|DD: DIR-810L, 2*EA6900@1GHz, R6300v1, RT-N66U@663, WNDR4000@533, E1500@353,
WRT54G{Lv1.1,Sv6}@250|FreshTomato: F7D8302@532|OpenWRT: F9K1119v1, RT-ACRH13, R6220, WNDR3700v4