WRT32X

Post new topic   This topic is locked: you cannot edit posts or make replies.    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.)
Goto page Previous  1, 2, 3 ... 14, 15, 16
Author Message
Hyperia
DD-WRT Novice


Joined: 24 Jun 2018
Posts: 11
Location: France

PostPosted: Thu Jun 28, 2018 7:33    Post subject: Reply with quote
ok, i'll doing that today, see you later and thanks for you help
Sponsor
Hyperia
DD-WRT Novice


Joined: 24 Jun 2018
Posts: 11
Location: France

PostPosted: Thu Jun 28, 2018 10:20    Post subject: Reply with quote
https://ibb.co/dAQEjo

Now, with the release 3.0-r36242, nothing forces me to immediately replace login idenfiants.

However, as soon as I click in any tab, I always find this warning message asking me to login again.

No ID works
ramx2
DD-WRT Novice


Joined: 03 Apr 2012
Posts: 38

PostPosted: Sun Aug 19, 2018 1:24    Post subject: Reply with quote
Reserved.

Last edited by ramx2 on Sun Aug 19, 2018 1:47; edited 1 time in total
spuriousoffspring
DD-WRT Guru


Joined: 05 Apr 2017
Posts: 981
Location: Louisiana, USA

PostPosted: Sun Aug 19, 2018 1:31    Post subject: Reply with quote
ramx2 wrote:
I flashed the WRT32X to OpenWRT then flashed it back to DDWRT, I'm having problems with the WIFI which is really slow... Is there a way to flash back the Original firmware from DDWRT?

After some deep reading so I've wiped the venom firmware partition Sad by flashing the Openwrt from the Venom UI?

Read the entire thread before you start.
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=316094

_________________
DD-WRT Installation & Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117

WRT32X DD-WRT Installation Procedure
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=315569

IPVanish OpenVPN Client Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=308565

FIRMWARE: OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33)
MODEM: ARRIS SURFBoard SB8200
ROUTER: Linksys WRT32X
USB NAS: Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
ramx2
DD-WRT Novice


Joined: 03 Apr 2012
Posts: 38

PostPosted: Sun Aug 19, 2018 1:48    Post subject: Reply with quote
spuriousoffspring wrote:
ramx2 wrote:
I flashed the WRT32X to OpenWRT then flashed it back to DDWRT, I'm having problems with the WIFI which is really slow... Is there a way to flash back the Original firmware from DDWRT?

After some deep reading so I've wiped the venom firmware partition Sad by flashing the Openwrt from the Venom UI?

Read the entire thread before you start.
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=316094


Yeah! I flashed it back to Venom, what's with your Linksys Venom v1.0.180404.58 (modified) firmware? what's special about it ?
Can we flash the WRT32X To Oem Linksys firmware wrt3200ACM ?
spuriousoffspring
DD-WRT Guru


Joined: 05 Apr 2017
Posts: 981
Location: Louisiana, USA

PostPosted: Sun Aug 19, 2018 4:35    Post subject: Reply with quote
ramx2 wrote:
Yeah! I flashed it back to Venom, what's with your Linksys Venom v1.0.180404.58 (modified) firmware? what's special about it ?

I made some minor changes in etc/config, removed some useless cron jobs and configured the logs for an external syslog server.
ramx2 wrote:
Can we flash the WRT32X To Oem Linksys firmware wrt3200ACM ?

I guess you could change the uboot environment variables to match a WRT3200, but that seems like a big step back in my opinion.

Give it some time and DD-WRT will get better on the WRT32X (now that Brainslayer has one of his own).

In the meantime, if DD-WRT isn't working for you, there are other open-source firmware options.

_________________
DD-WRT Installation & Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117

WRT32X DD-WRT Installation Procedure
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=315569

IPVanish OpenVPN Client Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=308565

FIRMWARE: OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33)
MODEM: ARRIS SURFBoard SB8200
ROUTER: Linksys WRT32X
USB NAS: Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
ramx2
DD-WRT Novice


Joined: 03 Apr 2012
Posts: 38

PostPosted: Mon Aug 20, 2018 0:55    Post subject: Reply with quote
The venom firmware isn't capable of giving me the full internet speed over the ethernet, it looks there's bottleneck in the firmware. I've even opened a ticket with Linksys to check the problem. The maximum speed I was able to get around 850~750 Mbps. I decided to flash OpenWrt to check if it has the same limitations. After doing the speed test I got the same Venom firmware results.

DDWRT firmware is capable to get me the full internet speed over the ethernet which is 940~+ Mbps, I assume OpenWrt has some sort of limitations, in which DDWRT doesn't. On OpenWrt 5Ghz didn't work, and DDWRT is only allowing me to get 60 Mbps over the Wifi :S
I'd rather to stay on Venom meanwhile until this router gots the full support, Which I really dislike since it's has a lot of limitations... We can't disable DHCP from the UI! Seriously! lol
That's why I've asked about the WRT3200 oem Firmware..
spuriousoffspring
DD-WRT Guru


Joined: 05 Apr 2017
Posts: 981
Location: Louisiana, USA

PostPosted: Mon Aug 20, 2018 3:25    Post subject: Reply with quote
ramx2 wrote:
The venom firmware isn't capable of giving me the full internet speed over the ethernet, it looks there's bottleneck in the firmware. I've even opened a ticket with Linksys to check the problem. The maximum speed I was able to get around 850~750 Mbps. I decided to flash OpenWrt to check if it has the same limitations. After doing the speed test I got the same Venom firmware results.

I wish I could verify for you, but my ISP's fastest available speed is 300/30. Sorry!

Since the Venom firmware is OpenWrt based and you had the same issue with OpenWrt firmware - I would post your question here too:
https://forum.openwrt.org/t/davidc502-wrt1200ac-wrt1900acx-wrt3200acm-wrt32x-builds

Almost certain to get a much faster response than from Linksys. Mr. Green

_________________
DD-WRT Installation & Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117

WRT32X DD-WRT Installation Procedure
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=315569

IPVanish OpenVPN Client Setup TUTORIAL
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=308565

FIRMWARE: OpenWrt SNAPSHOT r8217-2cc821e / LuCI Master (git-18.276.41146-280dd33)
MODEM: ARRIS SURFBoard SB8200
ROUTER: Linksys WRT32X
USB NAS: Western Digital BLACK 1 TB Hardrive + Startech USB 3.0 External SATA III Enclosure
Mastahh
DD-WRT Novice


Joined: 19 Oct 2013
Posts: 16

PostPosted: Thu Jul 18, 2019 10:55    Post subject: Reply with quote
Hi, so as I understand I can buy WRT32X and flash it to 3200ACM or DD-WRT.
Then I will have two firmwares, and can switch between them?

What about setting, where it is stored, also on same partition with firmware?
moisesmcardona
DD-WRT Novice


Joined: 22 Jun 2014
Posts: 44

PostPosted: Sat Jul 20, 2019 18:46    Post subject: Reply with quote
Installed the build 40400 in my wrt32x. So far, it is working fine Very Happy
_________________
Linksys WRT32X, Linksys EA6500 v1, TP-Link TL-WR842ND
Spectrum 940/35 mbit
Mastahh
DD-WRT Novice


Joined: 19 Oct 2013
Posts: 16

PostPosted: Fri Aug 23, 2019 5:20    Post subject: Reply with quote
HI All, i want to buy this router "Linksys AC3200 Dual-Band WiFi Gaming Router with Killer Prioritization Engine" I like the design. Is it possible to flash it to WRT3200ACM?
noslenwerdna
DD-WRT Novice


Joined: 06 Oct 2019
Posts: 3

PostPosted: Sun Oct 06, 2019 16:42    Post subject: Reply with quote
I just installed the firmware on my 32X and at first it would not take the img file. I was attempting the newest listed (v3.0 build 40559) and it seems that it was too large. I instead went with the oldest listed (v3.0 build 36247) and it worked like a charm. It's important to note that the oldest listed version was smaller than the newest, not by much but that seems to have made all of the difference.
weaklinks
DD-WRT Novice


Joined: 06 Oct 2019
Posts: 37

PostPosted: Mon Oct 07, 2019 2:03    Post subject: Reply with quote
Nothing working and the hardwired works wirelss is not working anymore on my router

here is the download
/tmp# wget https://download1.dd-wrt.com/dd-wrtv2/downloads/betas/
2019/10-01-2019-r41218/linksys-wrt32x/FW_WRT32X_1.0.666_DDWRT.img
Downloading 'https://download1.dd-wrt.com/dd-wrtv2/downloads/betas/2019/10-01-2019-r41218/linksys-wrt32x/FW_WRT32X_1.0.666_DDWRT.img'
Connecting to 185.84.6.100:443
# custom headers to add: 0
Writing to 'FW_WRT32X_1.0.666_DDWRT.img'
FW_WRT32X_1.0.666_DD 100% |*******************************| 11320k 0:00:00 ETA
Download completed (11591855 bytes)

The install
# sysupgrade -F -n FW_WRT32X_1.0.666_DDWRT.img
killall: watchdog: no process killed
Sending TERM to remaining processes ... connled logd rpcd netifd crond udhcpc siproxd uhttpd miniupnpd ntpd sleep ubusd askfirst dnsmasq /sbin/sysupgrade: line 237: can't open /proc/9011/cmdline: no such file
dnsmasq
Sending KILL to remaining processes ... askfirst
Switching to ramdisk...
Performing system upgrade...
cannot find ubi mtd partition rootfs1
libubi: error!: "/dev/" is not a character device
ubiupdatevol: error!: error while probing "/dev/"
error 22 (Invalid argument)
libubi: error!: "/dev/" is not a character device
ubiupdatevol: error!: error while probing "/dev/"
error 22 (Invalid argument)
sysupgrade successful
Goto page Previous  1, 2, 3 ... 14, 15, 16 Display posts from previous:    Page 16 of 16
Post new topic   This topic is locked: you cannot edit posts or make replies.    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.) All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum