Router/Version: Netgear WNR3500L
Firmware: DD-WRT v3.0-r33215M mega (08/25/17)
Kernel: Linux 3.10.107 #15794 Fri Aug 25 11:57:59 CEST 2017 mips
Previous: DD-WRT v3.0-r32868 mega (07/27/17)
Mode/Status: Reset: Issues/Errors: Failed to flash
Every build after the 7/27 build fails to flash on the device due to the size of the build and the 8MB chip.
Linksys E4200 Firmware: dd-wrt.v24-33215_NEWD-2_K3.x_mega-e4200.bin Kernel: Linux e4200 3.10.107 #15794 Fri Aug 25 11:57:59 CEST 2017 mips DD-WRT Previous: dd-wrt.v24-33180_NEWD-2_K3.x_mega-e4200.bin Mode/Status: Working with issues Reset: yes Issues/Errors: this router hasn't had time sync with this and 7 earlier firmwares - at one time I could time sync from the CLI but that doesn't work anymore - no time sync == no VPN - otherwise the router works fine so I can't say that it is bricked
Router/Version: RT-AC87U/
Firmware: DD-WRT v3.0-r33215 std (08/25/17)
Kernel: Linux 4.4.83 #1930 SMP Fri Aug 25 07:57:51 CEST 2017 armv7l
Previous: DD-WRT v3.0-r33006 std (08/03/17)
Mode/Status: Gateway/working
Reset: Yes, before and after
Issues/Errors:
Router/Version: RT-AC66U/A1
Firmware: DD-WRT v3.0-r33215M (08/25/17)
Kernel: Linux 3.10.107 #15778 Fri Aug 25 11:42:58 CEST 2017 mips
Previous: DD-WRT v3.0-r33006 giga (08/03/17)
Mode/Status: Repeater Bridge 5Ghz (AC/N-Mixed)/working
Reset: Yes, before and after
Issues/Errors: No: NTP Client does not set time
Edit: Wireless drops, rolling both back to 33006 _________________ Netgear XR500, R7800
Asus AC87Ua1
Repeater Bridge
Netgear R6400v2otp
Can't flash this version with the browser. It stays in 'upgrading firmware'. After 10 minutes powecycled the router. Router booted up with the previous version (r33006) with the default settings.
Reverted to the factory firmware, then flashed the factory to ddwrt version of r33215. That worked, but found the following issue's:
- USB support is not stable. When USB support is turned on the first time, it recognizes the USB sticks. But after a reboot it doesn't.
It only works if USB support is turned off and then apply settings and turned on again and apply settings.
- The NAS share's doesn't show up the windows network neighbourhood (It does in r33006).
Joined: 23 Aug 2017 Posts: 9 Location: Florida, USA
Posted: Sun Aug 27, 2017 1:35 Post subject:
Code:
Router/Version: Asus RT-N66U
Firmware: DD-WRT v3.0-r33215M big (08/25/17) (what's up with the M?)
Kernel: Linux 3.10.107 #15790 Fri Aug 25 11:54:07 CEST 2017 mips
Previous: 33006 big
Mode/Status: working on 2 identical units
Reset: no
Issues/Errors: none _________________ "Opportunity is often missed by most people because it is dressed in overalls, and looks like work."
Router/Version: Buffalo WZR-1750DHP Firmware: DD-WRT v3.0-r33215 std (08/25/17) Kernel: Linux 4.4.83 #1923 SMP Thu Aug 24 21:09:13 CEST 2017 armv7l Previous: 33006 Mode/Status: Working Reset: yes via web GUI reset to defaults Issues/Errors: none so far Uptime: 7mins.
Saw this under CPU....undefined EDSP, what is EDSP and why is it undefined.
router hasn't had time sync with this and 7 earlier firmwares - at one time I could time sync from the CLI but that doesn't work anymore - no time sync == no VPN - otherwise the router works fine so I can't say that it is bricked[/b]
I have onehundredninetythree.sixtyseven.seventynine.twohundredandtwo as NTP IP and it works perfectly with time sync. _________________ 2 times APU2 Opnsense 21.1 with Sensei
2 times RT-AC56U running DD-WRT 45493 (one as Gateway, the other as AP, both bridged with LAN cable)
3 times Asus RT-N16 shelved
E4200 V1 running freshtomato 2020.8 (bridged with LAN cable)
3 times Linksys WRT610N V2 converted to E3000 and 1 original E3000 running freshtomato 2020.8 (bridged with LAN cable)
Joined: 04 Jan 2007 Posts: 11564 Location: Wherever the wind blows- North America
Posted: Sun Aug 27, 2017 11:47 Post subject:
Whammy wrote:
No it doesn't. The WNR3500L fails to flash.
That's probably true...I don't have a WNR3500L unit but the Netgear units typically (from past experience) use more flash...one section for the CFE...and another (hidden/protected) for MAC address and I believe it was radio settings in another section of the flash. This causes the amount of usable flash for firmware to be lessened.
Just because it fits on one unit...doesn't mean it will work on every unit due to how the manufacture sets up CFE area and other hidden areas of the flash.
redhawk _________________ The only stupid question....is the unasked one.
Joined: 18 Jul 2017 Posts: 45 Location: Wisconsin, USA
Posted: Sun Aug 27, 2017 14:19 Post subject: Update
Router/Version: Linksys EA 6500v1
Firmware: DD-WRT v3.0-r33215M giga (08/25/17)
Kernel: Linux 3.10.107 #15778 Fri Aug 25 11:42:58 CEST 2017 mips
Previous: DD-WRT v3.0-r33006 giga (08/03/17)
Mode/Status: Gateway/AP
Reset: No
Issues/Errors: Wireless Drops seems to happen about twice
a day router says its broadcasting but no device can see or connect, also Ipv6 address seems to come and go. Can force address by going to the IPv6 page hitting save and apply settings this will issue an ip but a little while later its like the router forgets it and releases it without attempting to obtain a new one. Unless I go back and repeat the above step.
Reverting back to DD-WRT v3.0-r33006 giga (08/03/17)
Joined: 04 Jan 2007 Posts: 11564 Location: Wherever the wind blows- North America
Posted: Sun Aug 27, 2017 18:15 Post subject:
slobodan wrote:
I have onehundredninetythree.sixtyseven.seventynine.twohundredandtwo as NTP IP and it works perfectly with time sync.
It didn't work for me when in CB mode. I still have to manually set the date/time. I wonder how Kong fixed his builds for NTP time. His second (fixed) build of 33010 has the NTP time working now.
redhawk _________________ The only stupid question....is the unasked one.
Router/Version: Trendnet TEW828DRU
Firmware: DD-WRT v3.0-r33215 std (08/25/17)
Kernel: Linux 4.4.83 #1927 Fri Aug 25 07:38:00 CEST 2017 armv7l
Previous: DD-WRT v3.0-r33006 std (08/03/17)
Mode/Status: Gateway/AP
Reset: Yes
Issues/Errors: Router stable for ~15 mins then reboots, after which router reboots every couple of minutes. This behavior only happens when my other routers configured as client or repeater bridges are connected. Without client/repeater bridges router remains stable longer, but still requires a couple of reboots a day. Reverted to 33006.
Router/Version: Trendnet TEW828DRU
Firmware: DD-WRT v3.0-r33215 std (08/25/17)
Kernel: Linux 4.4.83 #1927 Fri Aug 25 07:38:00 CEST 2017 armv7l
Previous: DD-WRT v3.0-r33006 std (08/03/17)
Mode/Status: Client Bridge
Reset: Yes
Issues/Errors: Router exhibited the same behavior when configured as a Gateway/AP as the other router. When configures as a Client Bridge all functions appear to work properly, however it exhibits the same instability in which a reboot is required a couple of times a day to regain connectivity. NTP not updating. Reverted to 33006.
Router/Version: Trendnet TEW818DRU
Firmware: DD-WRT v3.0-r33215 std (08/25/17)
Kernel: Linux 4.4.83 #1927 Fri Aug 25 07:38:00 CEST 2017 armv7l
Previous: DD-WRT v3.0-r33006 std (08/03/17)
Mode/Status: Client Bridge/OpenVPN Client
Reset: Yes
Issues/Errors: After ~24 hours up time processor usage is at 84%, every thing was still functioning properly and the router was not overly hot. A reboot brought the processor usage back down to its normal 4% range. Will continue to monitor and downgrade if the issue persists. NTP not updating.
Joined: 26 Jun 2007 Posts: 262 Location: Trinidad & Tobago
Posted: Sun Aug 27, 2017 19:13 Post subject: wget no work with https urls
Router Model: Buffalo WZR-600DHP2
Firmware Version: DD-WRT v3.0-r33215 std (08/25/17)
Kernel Version: Linux 4.4.83 #1927 Fri Aug 25 07:38:00 CEST 2017 armv7l
Issues/Errors: wget does not work with https urls. If an https url is used this error is output: "wget: not an http or ftp url: https://rest_of_url".
Without going into the details, the reason I need wget to work with https urls is to wget an API url to send my IP address to Smart DNS type service. I feel as though this used to work in previous versions of dd-wrt, not sure when it stopped working. _________________ [everything is to be replicate]
