New build available with the latest beta wireless drivers. Let the testing begin.Since this has a new driver I would not rely on a backup and restore process.
Lets see if the new driver performs or crashes.
I came back to my house and I'll be darned if LEDE 23APR Developmental isn't still alive almost 24 hours after install. Getting good Speedtest speeds across the house still as well. Soon as it crashes I'll do BS DD-WRT
Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Mon Apr 24, 2017 18:45 Post subject:
Installed on my wrt3200acm. For me the 5GHz wireless is unusable. Signal level varies way up and down to non- existent. Since I use 5GHz primarily I have had to go else where. Back on Linksys latest at the moment. The signal was something that Brainslayer talked about over on git.
--bill _________________ Unifi Security Gateway:Unifi Firmware Netgear r7800:Voxel Firmware Modem:Netgear CM500V voice and Data. ISP:Comcast tutorial for flashing "WRT" series: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813 DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117 Kong DD-WRT Config Tutorial: http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/ I tried to be normal once. Worst 2 minutes ever.
24hrs on David's lede with the new drivers, still rolling on the wrt3200 and 5ghz. _________________ My "WRT" rant, and why I have gone ddwrt on x86, no more consumer routers. ( ac86u as access points & bridges )
New build available with the latest beta wireless drivers. Let the testing begin.Since this has a new driver I would not rely on a backup and restore process.
Lets see if the new driver performs or crashes.
Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Mon Apr 24, 2017 21:54 Post subject:
LookingForMyMojo wrote:
24hrs on David's lede with the new drivers, still rolling on the wrt3200 and 5ghz.
Tried david's latest 4.9 kernel build on my wrt3200acm. In my case the 5GHz showed lots of transfer issues on my simple iperf run. Had 1 second gaps of no transfer. Might not notice just web browsing.
New build available with the latest beta wireless drivers. Let the testing begin.Since this has a new driver I would not rely on a backup and restore process.
Lets see if the new driver performs or crashes.
I tried BS 4/24 build on WRT3200ACM and it keeps PORing, as confirmed via console log. Flashed factory, then re-flashed BS, same result. I even managed to get into the web page between PORs to perform a factory reset, as confirmed by console log.
Looks like Cybernook's Lede project will slow down since he don't own the WRT1900 anymore. David's Lede is based on beta build which I prefer Stable build.
So I am planning to move to either Gargoyle or DDWRT, my understanding Kong is no longer developing builds for WRT1900, it will be either this DDWRT build by BS or Gargoyle.
Anyone has used both care to comment which one is more stable. TIA
Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Tue Apr 25, 2017 13:26 Post subject:
apvm wrote:
Looks like Cybernook's Lede project will slow down since he don't own the WRT1900 anymore. David's Lede is based on beta build which I prefer Stable build.
So I am planning to move to either Gargoyle or DDWRT, my understanding Kong is no longer developing builds for WRT1900, it will be either this DDWRT build by BS or Gargoyle.
Anyone has used both care to comment which one is more stable. TIA
By the way, Mine is a WRT1900AC V2
I recently got a wrt3200acm. Before that I had a wrt1900acs v1, very similar to the ac v2 you have. Both DDWRT and Gargoyle ran well on them. I would suggest, based on my experience with the latest Brainslayer build on my wrt3200acm that maybe start with the 3/30/2017 build as the newest has the latest beta wireless drivers that are no at all solid on my wrt. Gargoyle runs really well for me. Link to good Gargoyle;
http://lantisproject.com/gargoyle_ispyisail/ _________________ Unifi Security Gateway:Unifi Firmware Netgear r7800:Voxel Firmware Modem:Netgear CM500V voice and Data. ISP:Comcast tutorial for flashing "WRT" series: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813 DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117 Kong DD-WRT Config Tutorial: http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/ I tried to be normal once. Worst 2 minutes ever.
Looks like Cybernook's Lede project will slow down since he don't own the WRT1900 anymore. David's Lede is based on beta build which I prefer Stable build.
So I am planning to move to either Gargoyle or DDWRT, my understanding Kong is no longer developing builds for WRT1900, it will be either this DDWRT build by BS or Gargoyle.
Anyone has used both care to comment which one is more stable. TIA
By the way, Mine is a WRT1900AC V2
I recently got a wrt3200acm. Before that I had a wrt1900acs v1, very similar to the ac v2 you have. Both DDWRT and Gargoyle ran well on them. I would suggest, based on my experience with the latest Brainslayer build on my wrt3200acm that maybe start with the 3/30/2017 build as the newest has the latest beta wireless drivers that are no at all solid on my wrt. Gargoyle runs really well for me. Link to good Gargoyle;
http://lantisproject.com/gargoyle_ispyisail/
Thanks, I will try Gargoyle and monitor DDWRT to see which one will be my daily driver. Thanks again.
Looks like Cybernook's Lede project will slow down since he don't own the WRT1900 anymore. David's Lede is based on beta build which I prefer Stable build.
So I am planning to move to either Gargoyle or DDWRT, my understanding Kong is no longer developing builds for WRT1900, it will be either this DDWRT build by BS or Gargoyle.
Anyone has used both care to comment which one is more stable. TIA
By the way, Mine is a WRT1900AC V2
I recently got a wrt3200acm. Before that I had a wrt1900acs v1, very similar to the ac v2 you have. Both DDWRT and Gargoyle ran well on them. I would suggest, based on my experience with the latest Brainslayer build on my wrt3200acm that maybe start with the 3/30/2017 build as the newest has the latest beta wireless drivers that are no at all solid on my wrt. Gargoyle runs really well for me. Link to good Gargoyle;
http://lantisproject.com/gargoyle_ispyisail/
I don't see any Gargoyle release for the WRT routers. Which firmware are you actually using?