Posted: Thu Sep 15, 2016 9:09 Post subject: RT-AC68U latest build. Not getting AC speed.
Hello,
I finally managed to change from Tomato Shibby to DD-WRT. It is working flawlessly, however i am unable to achieve wifi AC speed. On Asuswrt and Asuswrt-merlin i was getting as high as 800Mbps but on DD-WRT the wall is on 600Mbps. I have configured dd-wrt as follows:
-Mode: AC-Only (AC/N mixed tested same results)
-VHT80 with lower/upper (tested the 4 modes. no luck)
-Preamble: short
-WPA-2 AES personal
-Country: SPAIN
-802.11h: Loose (Tested off too)
-Beacon: 179 (working flawless on tomato and asuswrt-merlin, so i don't think it has to do with AC :S)
-EVerything else untouched
-Cannot select Manual channel beyond 40Mhz
-Client on same settings as with other firmwares on router (PCE-AC68u)
Any ideas what is going on? I have 4/5 signal strength bars and the link is stable at 600mbps for now.
Posted: Thu Sep 15, 2016 18:02 Post subject: Re: RT-AC68U latest build. Not getting AC speed.
novaprospekt216 wrote:
Hello,
I finally managed to change from Tomato Shibby to DD-WRT. It is working flawlessly, however i am unable to achieve wifi AC speed. On Asuswrt and Asuswrt-merlin i was getting as high as 800Mbps but on DD-WRT the wall is on 600Mbps. I have configured dd-wrt as follows:
-Mode: AC-Only (AC/N mixed tested same results)
-VHT80 with lower/upper (tested the 4 modes. no luck)
-Preamble: short
-WPA-2 AES personal
-Country: SPAIN
-802.11h: Loose (Tested off too)
-Beacon: 179 (working flawless on tomato and asuswrt-merlin, so i don't think it has to do with AC :S)
-EVerything else untouched
-Cannot select Manual channel beyond 40Mhz
-Client on same settings as with other firmwares on router (PCE-AC68u)
Any ideas what is going on? I have 4/5 signal strength bars and the link is stable at 600mbps for now.
Posted: Mon Sep 19, 2016 10:08 Post subject: Re: RT-AC68U latest build. Not getting AC speed.
<Kong> wrote:
novaprospekt216 wrote:
Hello,
I finally managed to change from Tomato Shibby to DD-WRT. It is working flawlessly, however i am unable to achieve wifi AC speed. On Asuswrt and Asuswrt-merlin i was getting as high as 800Mbps but on DD-WRT the wall is on 600Mbps. I have configured dd-wrt as follows:
-Mode: AC-Only (AC/N mixed tested same results)
-VHT80 with lower/upper (tested the 4 modes. no luck)
-Preamble: short
-WPA-2 AES personal
-Country: SPAIN
-802.11h: Loose (Tested off too)
-Beacon: 179 (working flawless on tomato and asuswrt-merlin, so i don't think it has to do with AC :S)
-EVerything else untouched
-Cannot select Manual channel beyond 40Mhz
-Client on same settings as with other firmwares on router (PCE-AC68u)
Any ideas what is going on? I have 4/5 signal strength bars and the link is stable at 600mbps for now.
Thank you very much!
Try EU regulation domain, Spain is untested only US/EU gets regularly tested.