Posted: Sat Jul 02, 2016 17:53 Post subject: Re: New build: DD-WRT v3.0 --- 30082 --- 2016/07/01
Router: DIR-615 i1
Firmware: r30082
Kernel: 3.10.102 #25639
Status: OK
Reset: Reset to defaults before/after flash
Errors: After saving and applying client bridge settings, the "applying settings animation" spun for an extended period of time, then the GUI became inaccessible (went to a blank white page) similar to http://svn.dd-wrt.com/ticket/3616 except I'm accessing it over the LAN.
Router: DIR-615 E3
Firmware: r30082
Kernel: 3.10.102 #25633
Status: OK
Reset: No
Errors: None
Router: TL-WDR3600
Firmware: r30082
Kernel: 3.10.102 #25611
Status: OK
Reset: No
Errors: None
Archer C7 V2.0 IL
Web upgrade: OK
Reset: No
Errors: Can't get IP for wired connected PC. WiFi connection was OK. After soft reboot of router PC got connection after some pause.
Router: Dlink DIR859 (AP only, DHCP/DNS/NAT/etc all disabled)
Firmware: DD-WRT v3.0-r30082 std (07/01/16)
Kernel: Linux 3.18.36 #14136 Fri Jul 1 04:25:29 CEST 2016 mips
Status: OK
Reset: Yes
Errors: No major issue (*)
(*) There are small issues configuring "Wireless Security" using Web UI. The password is not saved, I had to try several times until the password was actually saved (both using "Save" and "Apply Settings" with similar results).
After initial configuration, 5GHz radio was on, but not broadcasting (it appeared with unknown channel even if the channel was set and everything was correctly configured). After entering in Wireless "Advanced Settings" and "Apply Settings" (even without changing anything) activated the 5GHz radio.
After this, rebooted the router and everything seems to be working fine.
WNDR3700 V4
DD-WRT v3.0-r30082 std (07/01/16)
Linux 3.18.36 #14146 Fri Jul 1 04:39:41 CEST 2016 mips
previous ¬
DD-WRT v3.0-r30016 std (06/24/16)
Linux 3.18.35 #13662 Fri Jun 24 03:12:24 CEST 2016 mips
NO Reset
No Errors
QOS - ok
Recursive DNS - ok
Port Range Forwards - ok
SAMBA Share - ok
----:~# uptime
08:25:32 up 18:35, load average: 0.02, 0.01, 0.0