Joined: 05 Jun 2016
|Posted: Sun Jun 05, 2016 6:11 Post subject: bridge multiple ethernet intefaces not working
|I need some help as I've run out of paths to investigate.
I have a 4 port Ethernet card, I was setting up ddwrt x86 to work with. 1 port as the WAN and the other 3 as LAN ports. Its running in Hyper-V.
However, no matter how I configure the bridge for the LAN only the lowest numbered LAN port seems to work. The other two ports don't DHCP or forward packets.
I was able to identify that the ports are seen by the ddwrt with the "brctl showmacs" command. Connected hosts show up on the list on the correct ports but they cannot communicate.
all the interfaces are "UP" with the "ifconfig" command, and they all are "forwarding" as shown with the brctl showstp.
What else should I check. thanks in advance