In generally, except for these issues it is working properly.
Issues that need to be improved:
1) Internal Vertical and Horizontal antenna not selectable not work how is it work?
2) Transmission Power (Tx-Power): max 26dbm country code is BZ ( How up to 27 dbm(Official tp-link firmware up to 27dbm))
Is there testing? Write the answer please?
DD-WRT is also in development work began in 2013 (WiP) why are you still not released a firmware Does anyone have any information about this?
I was able to find the IP of the router. Now in it there is the openvrt system, and whit a lot of setting, which i don't understand. Really many settings.
And I'm not an expert at all.
Now I need, in my case, to recover old firmware.
Which isn't difficult.
Posted: Sun Feb 28, 2016 10:51 Post subject: I can't upgrade to dd wrt firmware for tp link 7210n
i use firmware tl-wr3020 for my tp link 7210n v2 but it says: Error code: 18005
Upgrade unsuccessfully because the version of the upgraded file was incorrect. Please check the file name.
Please help me!
I also upgraded my TL-WA7210N v2 to openwrt-15.05.1-ar71xx-generic-tl-wa7210n-v2-squashfs-factory.bin and it works very well alhought the internal antenna is not working and also the transmission power is too low.
I would like to go back to stock firmware but now I don't know how. I've looked all over the internet (spend hours turning back at the same websites over and over again trying to find a solution) and I cannot seem to find a stripped firmware from OpneWrt to stock. Tried even with WinSCP and no result. It sais that it cannot erase the firmware.
On the OpenWRT forum does not let me to register. Always says that they think I am a bot so I cannot register to their forum.
I also upgraded my TL-WA7210N v2 to openwrt-15.05.1-ar71xx-generic-tl-wa7210n-v2-squashfs-factory.bin and it works very well although the internal antenna is not working and also the transmission power is too low.
I would like to go back to stock firmware but now I don't know how. I've looked all over the internet (spend hours turning back at the same websites over and over again trying to find a solution) and I cannot seem to find a stripped firmware from OpenWrt to stock.
flash the attached stripped WA7210Nv2 factory firmware directly from OpenWrt web interface to go back to stock.
edit - do not flash this from DD-WRT web interface! the file must be used only for reverting back from OpenWrt web interface.
Last edited by GreyDoc on Thu Apr 14, 2016 12:29; edited 2 times in total
I also upgraded my TL-WA7210N v2 to openwrt-15.05.1-ar71xx-generic-tl-wa7210n-v2-squashfs-factory.bin and it works very well although the internal antenna is not working and also the transmission power is too low.
I would like to go back to stock firmware but now I don't know how. I've looked all over the internet (spend hours turning back at the same websites over and over again trying to find a solution) and I cannot seem to find a stripped firmware from OpenWrt to stock.
flash the attached stripped WA7210N v2 factory firmware directly from OpenWrt web interface
Thank you very very much!
Finally I can use the router as an range extender, again!
here are a couple of variants for WA7210Nv2, any of them should work:
- one obtained from WR710Nv2 build 29134
- one obtained from MR3020v1 build 29134
Last edited by GreyDoc on Sat Apr 23, 2016 14:06; edited 6 times in total
applied that firmware, and now I cant find the address
which address does it assign?
I've scanned 192.168.0.1 / 192.168.1.1 and cant find it.
it's because you flashed the factory-to-ddwrt file from openwrt - so it bricked. factory-to-ddwrt is for flashing ddwrt from factory firmware, as the name says
,