Posted: Wed Jan 13, 2016 6:41 Post subject: Linksys EA-6100 Support
I am trying to determine if I can install dd-wrt on a Linksys EA6100. I haven't found anything saying it isn't supported, but I also haven't found anything for the Mediatek chip. I have attached the photos of the internals.
While there is a build for the WHR-1166D, getting the first copy of DD-WRT onto it remains an issue. I have done some research, but as yet have had no success. There is some possibility that an image can be built that can be loaded onto the unit via TFTP, but I would have to learn a lot about the Linux build process and creating an image before I could do so myself.
Posted: Sat Sep 08, 2018 22:57 Post subject: Serial / TFTP
I was able to get a serial terminal open. Similar to the WRT1900AC. It is the 6-pin header (labelled J2). Pin 6 is ground (wouldn't solder for me), pin 5 is Tx, pin 3 is Rx. VCC is the square hole, pin 1, don't connect it. Settings are 57600 baud, 8N1.
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one, I am trying to update them.
Netgear R7800 - gateway, DHCP, QoS, VPN
TP-Link Archer C7 v2 x2 - WDS AP, WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - WDS Station
D-Link 615 C1 x 4 - not used
D-Link 615 E3 x 2 - not used
D-Link 825 B1 - WDS Station
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - WDS Station
UBNT loco M2 x2 - airOS
Asus N66U - backup Gateway
Netgear r6300 v1 - AP
Linksys E2500 - not used
Linksys EA2700 - not used
Linksys 160N v3 x2 - not used
Netgear WNDR3700v3 - not used
UBNT EdgeRouter X - not used