Joined: 30 Jan 2016
|Posted: Sat Jan 30, 2016 16:26 Post subject: TP-LINK tl-wa501g access point died after firmware
I have a tp-link access point model (tl-wa501g), it was causing problems on the network and sometimes it doesn't save my config so I decided to upgrade it with an official firmware
and it began upgrading and after finishing it rebooted then nothing happened and all leds were off except the power led was on and the network card shows cross as it does when the cable is unplugged, so could I flash it with the 4-pins serial port with this firmware (the third/last one that named TL-WA50xG V1 080909) here..
I did that before with a speedtouch adsl router but long time ago, and of course every device has a different way to do that, not all devices have the same way, so I need to know how to do that with this tp-link ap (tl-wa501g)
any help please
pics for the same ap