Here i sett the password, but i dont know where can is sett username :/
Quote:
Open the Wireless -> Wireless Security tab
Physical Interface Section
Security Mode : Must Match Primary Router and DD-wrt only works reliably with WEP or WPA2-AES
WPA Algorithms : Must Match Primary Router
WPA Shared Key : Must Match Primary Router
Key Renewal Interval (in seconds) : Leave default
Last edited by WVash on Tue Feb 17, 2015 7:28; edited 1 time in total
All wifi needs is a password/key. Are you perhaps referring to a captive portal, i.e., once you get connected via wifi, you're presented w/ a login screen that requires secondary authorization to proceed?
For repeate i need make wifi connection with same SSID and same password, but i cant type username.And this mean i cant repeate wifi connection, because if i join to new connection dont have internet connection, only simple local network.
Step 1.
Open the Wireless -> Basic Settings tab
Physical Interface Section
Wireless Mode : Repeater Bridge
Wireless Network Mode : Must Match Primary Router
Wireless Network Name(SSID) : Must Match Primary <<Original wifi SSID, i wanna repeate this Router exactly including exact case- Make sure you spell this correctly
Wireless Channel : Must Match Primary Router (This will disappear once you put it in RB mode, and isn't needed)
Wireless SSID Broadcast : Enable
Network Configuration : Bridged
Save
Step 2.
Virtual Interfaces Section
Add
Wireless Network Name(SSID) : Different from Primary Router <<My fantasy SSID, i wanna joint for this wifi connection
Wireless SSID Broadcast : Enable
AP Isolation : Disable
Network Configuration : Bridged
Save
Open the Wireless -> Wireless Security tab
Physical Interface Section
Security Mode : Must Match Primary Router and DD-wrt only works reliably with WEP or WPA2-AES
WPA Algorithms : Must Match Primary Router
WPA Shared Key : Must Match Primary Router <<Original wifi password
Key Renewal Interval (in seconds) : Leave default
Virtual Interfaces Section (note if you don't see this section your firmware should be atleast v24-sp2)
Security Mode : Must Match Physical Interface
WPA Algorithms : Must Match Physical Interface
WPA Shared Key : Must Match Physical Interface <<Fantasy wifi password
Key Renewal Interval (in seconds) : Leave default
Save
But where can i sett wifi username?
When i connection to my fantasy wifi, dont ask username only password, and this mean connection dont work.
Now we're finally getting somewhere. The reason I asked about the security mode is I had a feeling you were probably needing 802.1x, which is indeed what that service is requiring (look under the Android example, you’ll see this mentioned just below the SSID, “Secured with 802.1x”). It specifically requires PEAP and MSCHAPV2 for authentication (one of many 802.1x options). I’m not an expert in this area, but I don’t believe this option is available in all builds (it’s certainly not available in my recent Kong build, for example).
Posted: Wed Jan 13, 2016 13:30 Post subject: Repeat Wifi [UPC Wi-Free]
Hello,
I have the same Problem now. I am trying to repeat the UPC Wi-Free network. I am not able to connect my router N66U with it. What are the correct security settings in DDWRT (Phase 2)? Or is it general not possible?
But in DDWRT there isn´t a WPA2-Enterprise option. I think 802.1x is the correct field. But what I have to write into the empty fields? I only have a username and a password.
On my Android Cellphone I filled out the field "Identity" and "password" and it successful connects with UPC Wi-Free.
I am using DD-WRT v24-sp2 (02/04/15) big
(SVN revision 26138M) with my ASUS-N66U router.