Search found 4 matches
| Author | Message |
|---|---|
 Topic: Bricked Linksys WRT54G2 V1 Router |
|
| skrappjaw Replies: 3 Views: 7505 |
 Forum: Hardware DIY / Hardware Mods Posted: Mon Feb 03, 2014 15:38 Subject: Bricked Linksys WRT54G2 V1 Router |
| I had used OpenWRT temporarily, but it was so slow in the GUI and buggy that i couldn't flash any firmware from there. I put the router in fail safe by holding reset and powering the unit on and relea ... | |
 |
|
| Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
|
| skrappjaw Replies: 76 Views: 217608 |
Forum: Hardware DIY / Hardware Mods Posted: Mon Feb 03, 2014 15:17 Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
| The other side of the custom PCB. Only difference between this and my schem is that i jumped the 5v from the 7805 to one usb then to the other usb. | |
|
|
| Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
|
| skrappjaw Replies: 76 Views: 217608 |
Forum: Hardware DIY / Hardware Mods Posted: Mon Feb 03, 2014 15:15 Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
| I've tried all of the above except removing the 472 and placing my resistors directly in their place. This is because RH19,20,26 do not have a resistor placed between the solder points.
I built a p ... |
|
|
|
| Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
|
| skrappjaw Replies: 76 Views: 217608 |
Forum: Hardware DIY / Hardware Mods Posted: Mon Feb 03, 2014 4:34 Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod) |
| Not trying to revive a dead thread, but I've been trying for a few days to add a USB port to my wrt54gs v2 for a few days now. I'm not entirely sure how to identify one. Should i just randomly poke ... | |
|
|
| All times are GMT |