Search found 4 matches

Author Message
  Topic: Bricked Linksys WRT54G2 V1 Router
skrappjaw

Replies: 3
Views: 6779

PostForum: Hardware DIY / Hardware Mods   Posted: Mon Feb 03, 2014 15:38   Subject: Bricked Linksys WRT54G2 V1 Router
I had used OpenWRT temporarily, but it was so slow in the GUI and buggy that i couldn't flash any firmware from there. I put the router in fail safe by holding reset and powering the unit on and relea ...
  Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
skrappjaw

Replies: 76
Views: 203260

PostForum: Hardware DIY / Hardware Mods   Posted: Mon Feb 03, 2014 15:17   Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
The other side of the custom PCB. Only difference between this and my schem is that i jumped the 5v from the 7805 to one usb then to the other usb.
  Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
skrappjaw

Replies: 76
Views: 203260

PostForum: Hardware DIY / Hardware Mods   Posted: Mon Feb 03, 2014 15:15   Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
I've tried all of the above except removing the 472 and placing my resistors directly in their place. This is because RH19,20,26 do not have a resistor placed between the solder points.

I built a p ...
  Topic: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
skrappjaw

Replies: 76
Views: 203260

PostForum: Hardware DIY / Hardware Mods   Posted: Mon Feb 03, 2014 4:34   Subject: IMPULSE DRIVE on my wrt54gs v1 (usb mod)
Not trying to revive a dead thread, but I've been trying for a few days to add a USB port to my wrt54gs v2 for a few days now. I'm not entirely sure how to identify one. Should i just randomly poke ...
All times are GMT
Navigation
Jump to: