Search found 1768 matches
| Author | Message |
|---|---|
 Topic: Linksys MR5500 & MX5500 support |
|
| lexridge Replies: 15 Views: 2776 |
 Forum: Qualcomm Atheros based Hardware Posted: Fri Jan 24, 2025 6:03 Subject: Linksys MR5500 & MX5500 support |
| How does MR5500 compare to e.g. Netgear R7800 or Linksys EA8500 performance-wise? Someone at a local marketplace is selling a slightly used MR5500 for 75 €.
(I'm actually hunting for an MR7500, b ... |
|
 |
|
| Topic: Home automation |
|
| lexridge Replies: 1 Views: 22 |
Forum: General Questions Posted: Fri Jan 24, 2025 3:05 Subject: Home automation |
| You can install MQTT (Mosquitto) on DD-WRT via Entware. I am using it with Home Assistant and it works well. | |
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Fri Jan 24, 2025 2:59 Subject: Support for Linksys MR7500 |
| If no serial data and ethernet is dead, then you most likely fried the UART chip, among other things. Might as well send it in for RMA.
Sadly, It certainly is starting to look like this is indeed the ... |
|
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 23:46 Subject: Support for Linksys MR7500 |
| tried a lot of thing and with gtkterm i succeeded in a connection.
How do you know you succeeded with a connection? But no luck. Theres no data comming from the pins and the network is dead.. So ... |
|
|
|
| Topic: Linksys MR7350 Child Node Question |
|
| lexridge Replies: 2 Views: 64 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 23:01 Subject: Re: Linksys MR7350 Child Node Question |
| I have a Linksys MR7350 with several child nodes linked with it as a mesh system and tried to find out in the community forum/setup pages if adding DD-WRT to it could be possible if I wanted to keep a ... | |
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 6:13 Subject: Support for Linksys MR7500 |
| i have the same issue . the chipset is working but i cannot see anything. nobody knows why
Yeah, I have been following the mr7500 thread on openwrt forum too. I have seen your comments. Strange it's ... |
|
|
|
| Topic: [SOLVED] MR7350 no Wifi on 59302 |
|
| lexridge Replies: 12 Views: 261 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 5:07 Subject: [SOLVED] MR7350 no Wifi on 59302 |
| just enable a ax compatible mode on your 2.4 ghz interface. running a ax capable interface without ax is very unusual
Not at all unusual when using 2.4ghz for IoT devices only (which generally do not ... |
|
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 0:34 Subject: Support for Linksys MR7500 |
| Here's a pic | |
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 0:31 Subject: Support for Linksys MR7500 |
| @seth_space Are you SURE you have the pins connected correctly and to the correct header?
There are two headers on the left hand front of the router. You want to use the 5 pin connector to the right ... |
|
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Thu Jan 23, 2025 0:17 Subject: Support for Linksys MR7500 |
| @seth_space I use minicom on Fedora but yes, as @kp said putty is available for Linux as well, but I prefer minicom. Also, you do not have to sudo to run either or any of these and there is no reason ... | |
|
|
| Topic: New Build - 01/14/2025 - r59171 |
|
| lexridge Replies: 37 Views: 2718 |
Forum: Qualcomm Atheros based Hardware Posted: Wed Jan 22, 2025 19:46 Subject: New Build - 01/14/2025 - r59171 |
| Issues/Errors: spontaneously reboots under even modest load
The router operates fine for hours at low load, like one client that's only streaming audio, but anything even a little heavier, like eve ... |
|
|
|
| Topic: [SOLVED] MR7350 no Wifi on 59302 |
|
| lexridge Replies: 12 Views: 261 |
Forum: Qualcomm Atheros based Hardware Posted: Wed Jan 22, 2025 19:40 Subject: [SOLVED] MR7350 no Wifi on 59302 |
| Yep, same for the mx4300 as well. However both mr7350 and mx4300 will work if you change the radio to AX only, just as I suspected. Not ideal. lol
EDIT: This does not appear to affect WDS or 802.11 ... |
|
|
|
| Topic: [SOLD] EA8500 and WRT1200ac with DD-WRT installed for sale |
|
| lexridge Replies: 7 Views: 4731 |
Forum: Search & Find, Sales & Offers Posted: Tue Jan 21, 2025 19:41 Subject: [SOLD] EA8500 and WRT1200ac with DD-WRT installed for sale |
| How could the EA8500 have dd-wrt on it when it says in the description:
>>>>>>>BRAND NEW - NEVER OPENED - ORIGINAL PACKAGING<<<<<<<<< |
|
|
|
| Topic: Support for Linksys MR7500 |
|
| lexridge Replies: 114 Views: 3328 |
Forum: Qualcomm Atheros based Hardware Posted: Tue Jan 21, 2025 5:48 Subject: Support for Linksys MR7500 |
| Just tested alpha release r59280M. The 6ghz channels now show up including PSC channels. I tried several channels including PSC and non-PSC channels but my Pixel phone never could see the 6ghz AP. Als ... | |
|
|
| Topic: MR5500 - USB hard drive mount issue (updated subject) |
|
| lexridge Replies: 32 Views: 1039 |
Forum: Qualcomm Atheros based Hardware Posted: Mon Jan 20, 2025 17:46 Subject: MR5500 - USB hard drive mount issue (updated subject) |
| You are not specifying which wlan is disconnecting. Is it 2.4 or 5ghz? If it's 2.4ghz, you need to get into Advanced Settings and turn off Legacy Rates 11b. Doing this solved 100% all my disconnection ... | |
|
|
| All times are GMT |